High limit value must be higher than low limit value. The CRC of OMMF serial number is not valid.ĭiverting weight low greater than high limit The Dynamic scale serial number entered is not compatible with the checksumĪ wizard is already started and system can’t run several wizard in the same timeĭefault Differential weighing not available The base serial number entered is not compatible with the checksum Delay too long.Ī display of BAS-01-011 or DBX-01-011 indicates that the mailing system can not modify status of last active operator. Enter the desired value for the Low Funds Threshold and select OK.įailed to send internal delayed event. To change the Low Funds Threshold, do the following:Ĥ. When your available funds reach this threshold value, you will receive the message “Low Funds Warning”. The mailing system warns you when your available funds reach a Low Funds Threshold which you can change to suit your needs. The mailing system is warning you that the amount of available funds has reached a low level. Enter the desired value for the High Value Threshold and select OK. (Menus may vary slightly depending on the model.)Ĥ. To change the High Value Threshold, do the following: If you attempt to print a postage amount that exceeds this threshold, you will receive the message “High Value Amount Error”. ![]() The mailing system allows you to set a limit (threshold) to the postage value allowed to be printed. The postage amount requested exceeds the High Value Threshold. To avoid the message, perform this process and the beginning or end of the month. If the time is exceeded, a “90 or 109 Day Security Timeout” message will be displayed and postage printing is disabled. USPS regulations require that a mailing machine must communicate with the manufacturer’s host server within certain reset times. To Avoid A PSD Postal Inspection Required message, perform this process and the beginning or end of the month.ĩ0 day or 109 day time limit for server communication reached To Clear A PSD Postal Inspection Required message: If the time is exceeded, a “Postal Inspection Required” message will be displayed and postage printing is disabled. To Avoid A PSD Locked message, perform this process and the beginning or end of the month. Press the “Home” button to return to the home screen. – The mailing machine will indicate when the call is complete.Ħ. The mailing system will contact the server to perform the inspection. Note: An analog phone line or LAN connection must be plugged into the mailing system to perform a Postal Inspection.ĥ. If the time is exceeded, a “PO LOCKOUT” message will be displayed and postage printing is disabled. ![]() ![]() Remove all mail pieces from from the mailing system and press START.ĩ0 day time limit for server communication reached Mail piece in base when Start Button pressed.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |